Stainless Steel Mesh Face Screens for Glycerin Pressure Leaf Filters
Woven screen sets for approved glycerin pressure leaves. Define actual stream chemistry, viscosity, leaf geometry, drainage and solids-filtration target.
Woven Screen Set Within the Glycerin Filter Leaf
The ordered parts are woven working-face screens and separately specified backing pieces in a glycerin pressure leaf. They differ from a cylindrical glycerin strainer and from purification intended to remove dissolved chemicals. Complete frame, manifold and process plant are separate.
Explore the main metal disc filter elements showcase for related metal mesh constructions.
Metal-only supply covers the component body and metal fittings expressly agreed in the quotation. Seals, gaskets and complete equipment are separate.
Actual Stream Chemistry and Solids
Identify crude or refined stream, remaining salts, water, reagents or other relevant constituents. State temperature-dependent viscosity, solids and filter-aid use. Provide flow and clean/loaded restriction. Mesh filtration does not establish pharmaceutical purity or removal of dissolved salts and water.
Specify the Complete Component
Send the leaf section and profile with captured margins, outlet clearance and layer order. Define directional wire data, rating/test basis, support contact and any agreed joining. Record piece counts per leaf and quantities of complete screen sets.
Include the component revision, mating-interface drawing and the required exposed flow area. Agree the joints, support relationship and any purchaser-provided fitting sample before fabrication.
Information for a Comparable Quotation
| Requirement | Details to provide |
|---|---|
| Screen set | Face weave, backing and drainage order |
| Geometry | Leaf outline, retained edge and outlet |
| Glycerin | Actual chemistry, viscosity, solids and filter aid |
| Trial | Passage, drainage, cleaning and records |
Drainage and Purity-Test Boundaries
Trial retained solids, passage, drainage and cleaning recovery in the approved leaf assembly. Agree material identity, geometry and required residue/documentation checks. Related screens illustrate construction rather than validated chemical-purity results.
Use the intended mating assembly and purchaser-approved test plan. Agree dimensional inspection and operating acceptance separately; a related construction photograph cannot replace these checks.
Cleaning, Inspection and Repeat Supply
Specify the cleaning method, chemicals, temperature and permitted mechanical handling. Inspect the mesh, edges, joints and supports after cleaning and agree when the component should be rejected or replaced.
For repeat orders, use the accepted component drawing and material specification with the same inspection requirements. Identify changes in fluid, particles, loading or installation before reusing a previous specification.
Product Enquiry FAQ
Send the component and holder drawings, metal and mesh requirements, operating conditions, quantity and acceptance criteria. Unspecified dimensions or duties can be marked for review.
No. The face pieces, backing order and leaf outlet clearance require a dedicated drawing even if the working cloth is related.
No. This enquiry covers the agreed metal component. Sealing parts, housings and complete equipment are separate.
They show related component or material construction from the existing library. The supplied item follows the agreed drawing and sample acceptance; the images are not an installed-service case study.
Send Your Component and Mating Drawings
Describe the installation, material, mesh requirement and quantity. Maidong can review the requested metal component for fabrication and quotation.